Have you used your Titanlight so much that you've worn out the wick?

TITANLIGHT WICK

HOW DO I REPLACE IT?

To replace it you will need two main things:
a pair of sharp scissors like xShear , tweezers and lots and lots of patience.

1. Remove the flame guard by pressing the brass pin and holding the guard down.
2. Remove all the cotton from the lighter, you can use napkins to absorb the excess liquid and gloves to avoid making a mess.
3. Remove the old wick.
4. If necessary, clean the bottom of the wick with cotton wool soaked in alcohol.
5. Cut the end of the new wick at a 45° angle with scissors.
6. Moisten the cut end with alcohol.
7. Holding the cut end still, pull the opposite side to lengthen it and reduce the cross-section.
8. Insert the new wick from the top of the lighter, being careful not to fray it.
9. After inserting the end of the wick into the hole, gently guide it in. If it frays, cut it off and start over.
10. Once you can see the wick in the fuel compartment, grab it and pull it out with tweezers, leaving it protruding from the top hole about 1 inch (2.5 cm).
11. Fold the wick in the cotton in layers, this maximizes the surface area in contact and increases the absorption of the fuel.
12. Once everything is closed, cut the excess wick that is sticking out.

DON'T HAVE A LIGHTER? (Or have you lost the desire to replace the wick and decided to buy a new one directly?)